The main advantages of using differential locks include:
- Increased traction: Differential locks enable better utilization of driving power by evenly distributing force to the wheels, allowing for improved traction on difficult terrain.
- Enhanced control: By being able to lock the differential mechanism, the driver gains greater control over the vehicle, which is particularly important in extreme terrain conditions and improves passenger safety.
- Component protection: By improving traction and control, differential locks can also contribute to reducing the wear of other drivetrain components, leading to increased durability and long-term savings.
Regardless of the terrain vehicle model, our differential locks are designed for maximum effectiveness and durability, proving themselves in rally conditions where reliability is crucial. This ensures reliability and durability for our customers even in the toughest terrain conditions. Our company places great emphasis on research and development to provide our customers with products that meet the highest quality and technological standards.
The RD132 pneumatic 100% differential lock fits the following vehicles:
- Toyota Land Cruiser 71, 76, 78, 79, 100, 105 – front axle (vehicles from 1998 with a solid axle)
- Toyota Land Cruiser Prado 90, 120, 150 – rear axle (vehicles from 1996, ring gear mounted with 10 bolts)
- Toyota Land Cruiser 40, 55, 60, 62, 70, 73, 74, 75, 80 – front axle (carrier bearing inner diameter 50 mm, ring gear mounted with 10 bolts)
- Toyota Bundera, Land Cruiser II, LJ70, RJ70 – front axle (carrier bearing inner diameter 50 mm, ring gear mounted with 10 bolts)
- Toyota Bundera, Land Cruiser II, LJ70, RJ71 – rear axle (vehicles up to 1985, carrier bearing inner diameter 50 mm, ring gear mounted with 10 bolts)
- Toyota HiLux, Pickup, Hiace, Fortuner – all models with a solid axle (carrier bearing inner diameter 50 mm)
- Toyota Hilux 4x4 – rear axle, all models (in vehicles up to 1988, carrier bearings with an inner diameter of 50 mm from a newer model must be used during installation)
FJ Cruiser 8" non-factory locker model 2006 to 09 rear
Specification
| Axle Spline |
30 tooth, Ø33 mm [1.31”] |
| Ratio Supported |
All |
| Ring Gear ID |
126.0 mm [4.96”] |
| Ring Gear OD |
200 mm [8”] |
| Ring Gear Bolts |
10 bolts on Ø160 mm [6.30”] |
| Ring Gear Torque |
95 Nm [70 ft-lb] |
| Backlash |
0.15–0.25 mm [0.006–0.010”] |
| Bearing Cap Torque |
95 Nm [70 ft-lb] |
An air compressor is required for proper operation.
Index: RD132
Polski
English
