Wheel spacers with a thickness of 35mm, featuring a 5x139.7mm bolt pattern and a 108.1mm center bore with a centering flange. These spacers are meticulously crafted from anodized aluminum 6061 in the T6 state, providing significantly improved strength characteristics compared to the commonly used PA21 alloy spacers. They come with hardened steel studs featuring an M12x1.25 thread.
Price includes a set of 4 spacers.
Compatible with the following vehicles:
SUZUKI Jimny
SUZUKI Samurai
SUZUKI Sidekick
SUZUKI Vitara
SUZUKI GRAND VITARA 1
DAIHATSU ROCKY, FEROZA
Jeep CJ3 1966-1982
Jeep CJ5 1959-1983
Jeep CJ5A 1966-1968
Jeep CJ6 1959-1975
Jeep CJ6A 1966-1968
Jeep CJ7 1976-1986
DIMENSIONS:
Thickness: 35 mm
Number of Bolts: 5
Bolt Pattern: 139.7mm
Center Bore Diameter: 108.1mm
Thread Size: M12x1.25
Proper installation is to be performed by a trained professional with sufficient knowledge of these products. The following points are guidelines only:
1) A torque wrench (no air tools) is required for the safe and proper installation of your new wheel spacers or adapters Be sure to remove all corrosion from your vehicle's hub and rotor using sandpaper, a wire brush or a wire wheel to ensure correct centering and seating of the spacer.
2) Make sure that the spacer or adapter seats completely flush against the hub of the vehicle and that the wheel seats completely flush against the face of the spacer.
3) Make sure that the wheel spacers or adapters have studs with a thread pitch that matches your vehicle's studs If they do not, additional lug nuts will be required
4) Your vehicle's OEM wheel studs may be longer than the spacer is thick. If that is the case, there are a couple of options:
- Your factory wheel studs can be cut/trimmed down or replaced with longer studs
- Your wheels may have pockets or cavities between the mounting holes. If these pockets are of sufficient size and shape to accommodate your vehicle's studs, you may not have the modify the studs
5) Never install wheels onto spacers if the vehicle's factory studs make contact with the back of the wheel. Make sure to confirm that the back of the wheel seats completely flush against the face of the spacer
In Suzuki Jimny with manual hub locks, the center flange may obstruct the installation of spacers on the front axle. We recommend purchasing spacers without a center flange for the front and with a flange for the rear.
Polski
English
